TM-9-2320-272-23-3
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 3 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-3 - Page 378 of 1469
OIL COOLER FILTER HEAD REMOVAL
CAUTION
•
Clean area around hoses before removal to prevent entry of dirt. Damage may occur if
dirt or dust enters transmission.
•
Cap or plug all open hoses and connections immediately after disconnection to prevent
contamination. Failure to do this may result in transmission damage.
NOTE
•
Have drainage container ready to catch oil.
•
Tag hoses for installation.
•
Use drain pans to retain leaking/draining fluids. Refer to local procedures and plans for
preventing and responding to fluid spills or leaks. Comply with local regulations when
disposing of clean up material and leaked and spilled fluids.
1.
Remove oil filter supply hose (Figure 2, Item 5) from adapter elbow (Figure 2, Item 4).
2.
Remove supply hose (Figure 2, Item 6) from adapter elbow (Figure 2, Item 7).
3.
Remove three locknuts (Figure 2, Item 8), screws (Figure 2, Item 3), and oil filter head (Figure 2, Item 2) from
oil filter bracket (Figure 2, Item 1). Discard locknuts.
6
7
8
1
3
4
5
M8071DAA
2
Figure 2.
Oil Filter Cooler Head Removal.
END OF TASK
TM 9-2320-272-23-3
0381
0381-3
Back to Top
