TM-9-2320-273-10
TRUCK, TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; OPERATOR’S MANUAL
DECEMBER 2012
TM-9-2320-273-10 - Page 139 of 452
OPERATING PROCEDURES - CONTINUED
WARNING
Due to increased weight and raised center of gravity on
vehicles equipped with Crew Protection Kit, vehicle operator
must be aware of differences in driving characteristics and
adjust driving accordingly. Failure to comply may result in
damage to equipment and possible injury or death to
personnel. Seek medical attention in the event of an injury.
The following procedures are required to bring the equipment from OFF through
STANDBY condition to FULL OPERATION:
1. Perform all operator/crew Before, During, and After Operation PMCS as required
in WP 0024 and WP 0025.
2. Perform Operator PMCS for auxiliary equipment installed on vehicle. Refer to
associated TMs.
3. Review operating instructions prior to performing mission. Refer to operating
procedures in WP 0007 through WP 0014 and Operation Under Unusual
Conditions, WP 0015.
4. If trailer is connected to fifth wheel, ensure fifth wheel primary and secondary
locks are engaged as described in Fifth Wheel Operation, WP 0012.
5. Ensure wheel chocks are removed from tractor and trailer prior to operation.
Refer to Placing Vehicle in Motion, WP 0010.
6. Operate vehicle IAW operator instructions in WP 0007 through WP 0014.
END OF TASK
DECALS AND INSTRUCTION PLATES
The operator must become familiar with the decals and instruction plates associated
with equipment operation. In addition, all safety related warning and caution decals and
instruction plates must be understood and adhered to during operation (WP 0014).
END OF TASK
PREPARATION FOR MOVEMENT
Refer to Towing Vehicle WP 0021 for preparation for movement procedures.
END OF TASK
END OF WORK PACKAGE
TM 9-2320-273-10
0006
0006-3/4 blank
Back to Top
