TM-9-2320-273-34
TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1980
TM-9-2320-273-34 - Page 664 of 801
TM 9-2320-273-34
w.
Remove four capscrews (1, fig. 19-14), mounts (2), washers (3), and nuts (4). There is one of
each at each front cab corner and two of each at the center rear of the cab. (Rear mount location shown.
)
Figure 19-14. Remove/Install Cab Mounts.
In step w, lift cab slowly and check
for parts which may still. be connected
to cab and vehicle structure.
x.
Slowly raise cab up and off of cab mount, then lower to ground carefully.
19-2. Dismantling and Reassembly.
If the cab is being replaced, the existing cab can be dismantled and
the new cab built-up, as necessary, by using the old cab as a guide. See also maintenance procedures in
TM 9-2320-273-20 for instructions on replacing specific parts.
19-3. Installation.
a.
Inspect all four cab mounts on vehicle frame. Check for cracks or other damage. Replace, if
necessary.
b.
Install four mounting capscrews (1) from inside cab (fig. 19-14).
19-13
CAUTION
Back to Top
