TM-9-2320-273-34
TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1980
TM-9-2320-273-34 - Page 666 of 801
TM 9-2320-273-34
(3) Connect tachometer cable to tachograph.
(4)
Connect speedometer cable to tachograph.
(5)
Install heater.
(6)
Install air cleaner inlet tube.
(7)
Install both front fenders.
(8)
Install radiator support rods.
(9)
Install hood.
(10)
Connect battery cables.
(11)
Fill radiator with coolant. (Refer to TM 9-2320-273-20.)
x.
Startup and operate engine. (Refer to TM 9-2320-273-1 O.) Check operation of the following.
(1)
Compressed air and brake systems.
(2)
All lighting systems.
(3)
Electrical Horn.
(4)
Steering Gear.
(5)
All other components that were installed in replacement cab.
Y.
Road test vehicle and check for cab vibration.
Section II, HOOD
19-4. Disassembly
x
a.
Remove each of four hood hook brackets (fig. 19-15) by removing two screws, washers, and
nuts from each.
b.
Remove each of two hood handles by removing four screws, washers, and nuts from each.
c.
Remove either side panel by removing 14 capscrews, washers, and nuts.
d.
Remove either top panel from the center panel by removing 14 capscrews, washers, and nuts;
then remove capscrew and nut holding hood brace.
e.
Remove either locating pin by removing four screws, washers, and nuts.
19-5. Reassembly.
a.
b.
c.
d.
e.
f.
Mount each locating pin on center panel and secure with four screws, washers, and nuts.
Mount top panels on center panel and secure each panel with 14 capscrews, washers, and nuts.
Install both hood braces and secure each with capscrew and nut.
Mount side panels on top panels and secure each with 14 capscrews, washers, and nuts.
Mount each hood handle on side panel and secure with four screws, washers, and nuts.
Mount two hook brackets cn each side panel and secure with two screws, washers and nuts.
19-15
Back to Top
