TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 685 of 801

TM 9-2320-273-34

20-2. Winch Assembly Removal.

To remove the winch assembly as a unit (less the hydraulic pump) follow

the procedures as outlined.

a. Preparation.

(1)

Remove spare tire (M916 only).

(2)

Remove spare tire hoist (M916 only).

(3)

Drain oil from hydraulic reservoir (approximately 42 gal) as follows:

(a)

Loosen nut and slide cover plate on top of hydraulic reservoir to one side.

(b)

Using a suction pump, pump oil from reservoir into a suitable drum.

(4)

Disconnect all four lines at hydraulic pump (fig. 20-1) and continue draining the oil

(approximately one gallon). After draining, reconnect the lines.

b. Removal.

(1)

Disconnect two hydraulic lines at base of hydraulic reservoir (fig. 20-1).

(2)

Disconnect trailer receptacle bracket (fig. 20-2) by removing three capscrews, washers,

and nuts.

Figure 20-2. Disconnect Trailer Receptacle Mounting Bracket.

20-2