TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 681 of 801

TM 9-2320-273-34

In step e, hold the bottom of glass to prevent

it from falling out.

9.

Remove nut at base of vertical window channel and a screw at top of the channel; then pull

out the channel.

h.

Slide glass out from bottom of door.

i.

Remove four nuts and Iockwashers that fasten inner door handle to door panel and pull out

the inner door handle. Remove two screws from inner door pull, if desired.

i.

Remove four screws that fasten window cranking mechanism to door panel and remove the

mechanism.

k.

Remove lower door latch by removing clip from rod; then remove four nuts and Iockwashers

that fasten the latch to the door frame. Pull out the door latch.

/.

Remove vent window (fig. 19-21 ) by pulling the rubber seal out to gain access to the fasten-

ing screws. Remove the fastening screws; then take out the complete vent window and frame.

TA 074452

Figure 19-21. Remove/Install Vent Window.

19-30

CAUTION