TM-9-2320-280-20-2
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3
JANUARY 1996
TM-9-2320-280-20-2 - Page 661 of 951
10.
Install washer (20) and access plug (19) to geared hub (3). Tighten access plug (19) to 8-13 lb-ft
(11-18 N
•
m).
11.
Install lower ball joint (4) and geared hub (3) on lower control arm (23). Ensure lower ball joint (4) is
below lower control arm (23).
NOT E
Ensure outer capscrews on front ball joints are installed from top down, and
inner capscrews are installed from bottom up for M1123 and “A2” series
vehicles only.
12.
Secure lower ball joint (4) to lower control arm (23) with four washers (21), capscrews (22),
washers (21), and locknuts (25). Tighten locknuts (25) to 35 lb-ft (47 N
•
m).
CAUTION
Do not loosen slotted nut to install cotter pin. Doing this may result in
damage to equipment.
13.
Tighten slotted nut (2) on lower ball joint (4) to 73 lb-ft (99 N
•
m). Install cotter pin (1).
6 - 1 1 .
GEARED HUB REPLACEMENT (Cont'd)
TM 9-2320-280-20-2
Change 2
6 - 2 9
Back to Top
