TM-9-2320-280-20-2

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 2 OF 3

JANUARY 1996
TM-9-2320-280-20-2

  TM-9-2320-280-20-2 - Page 718 of 951

This task covers:
a. Removal
b. Installation
Equipment Condition
• Wheels chocked and parking brake released
(TM 9-2320-280-10).
• Muffler and insulator removed (para. 3-48).
TM 9-2320-280-20-2
7-14
Change 3
7-6. PARKING BRAKE ROD REPLACEMENT
NOTE
The following procedure applies to vehicles with serial numbers
USBL Eff. 1 through 44824.
1.
Remove clip (1) and open boot (2) to allow access to clevis pin (4).
2.
Remove cotter pin (9), washer (8), and clevis pin (4) from clevis (5) and bellcrank (3). Discard cotter
pin (9).
3.
Disconnect spring (7) from brake rod (6).
4.
Remove cotter pin (17), washer (16), clevis pin (15), and brake rod (6) from brake cable (18). Discard
cotter pin (17).
5.
Remove clevis (5) and clevis (19) from brake rod (6).
NOTE
Perform steps 6 and 7 if replacing spring. If not replacing spring,
go to b., installation.
6.
Remove locknut (10), washer (11), capscrew (13), washer (11), spring (7), and spacer (12) from
body (14). Discard locknut (10).
7.
Install spacer (12) and spring (7) to body (14) with washer (11), capscrew (13), washer (11), and
locknut (10).
1.
Install clevis (5) and clevis (19) on brake rod (6).
2.
Install brake rod (6) to brake cable (18) with clevis pin (15), washer (16), and cotter pin (17).
3.
Install clevis (5) on bellcrank (3) with clevis pin (4), washer (8), and cotter pin (9).
4.
Connect spring (7) to brake rod (6).
5.
Close boot (2) and install clip (1).
b. Installation
a. Removal
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two cotter pins (Appendix G, Item 12)
Locknut (Appendix G, Item 79)
Manuals/References
TM 9-2320-280-10
TM 9-2320-280-24P


Back to Top