TM-9-2320-280-20-3
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3
JANUARY 1996
TM-9-2320-280-20-3 - Page 1068 of 1168
TM 9-2320-280-20-3
Change 1
D - 9 5
Section II.
I L L U S T R ATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
1.
Install four tiedown straps (11) in cable tie holders (10) and secure wires (2) to cable tie holders (10)
with tiedown straps (11).
2.
Install two loop clamps (4) on wires (2) of body harness connector and receptacle with screws (3),
washers (8), and nuts (9).
3.
Install two loop clamps (12) on wires (2) of engine harness connector and receptacle with screws (3),
washers (8), and nuts (9).
4.
Cut two 48-in. (1,219.2 mm) sections of conduit insulation (5).
5.
Remove ten tiedown straps (7) from wires (2) of body harness connector and receptacle.
6.
Position two sections of conduit insulation (5) over wires (2) of body harness connector and receptacle
and secure with tape (6).
7.
Cut two 54-in. (1,371.6 mm) sections of conduit insulation (13).
8.
Remove twelve tiedown straps (7) from wires on engine harness connector and receptacle.
9.
Position sections of conduit insulation (13) over wires (2) on engine harness connector and receptacle
and secure with tape (6).
Figure D-108.
Terminal Strip Installation.
I T E M
M AT E R
I A L S
N O .
R E Q ’ D
D E S C R
I P T
I O N
N S N / PA RT NUMBER
3
4
Screw
4
2
Loop Clamp
5
2
Conduit Insulation:
48 in.
68240
6
AR
Tape
8
4
Washer
9
4
Nut
11
4
Tiedown Strap
12
2
Loop Clamp
13
2
Conduit Insulation:
54 in.
68243
Back to Top
