TM-9-2320-280-20-3

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; UNIT MAINTENANCE; VOLUME 3 OF 3

JANUARY 1996

TM-9-2320-280-20-3 - Page 1080 of 1168

TM 9-2320-280-20-3

Change 1

D - 1 0 7

Section II.

I L L U S T R ATED MANUFACTURING INSTRUCTIONS (Cont'd)

INSTRUCTIONS (CONT’D):

34. Cut electrical wire (2) to length as shown.

35. Connect two terminal lugs (1) on wire (2).

36. Install wire (2) and tip jack lead (3) marked 5 on mount hole (10) on mini-box bottom section (9) with

washer (11), screw (7), and nut (8).

37. Connect wire (2) to terminal strip (4) marked D with screw (5).

38. Connect tip jack lead (3) marked 1 to terminal strip (6) marked H with screw (5).

39. Connect tip jack lead (3) marked 3 to terminal strip (6) marked B with screw (5).

40. Connect tip jack lead (3) marked 4 to terminal strip (6) marked C with screw (5).

41. Connect tip jack lead (3) marked 6 to terminal strip (6) marked A with screw (5).

42. Using existing drive pin, punch out four screw mount holes (14) in mini-box top section (12).

43. Install plug (16) and connector (15) as shown.

44. Install mini-box top (12) on bottom section (9) with four existing screws (13).

Figure D-113. Test Module Assembly (Cont’d).