11-46. WEAPON STATION HATCH HOLDDOWN STRIKER REPLACEMENT
This task covers:
a. Removal
b. Installation
a. Removal
1.
Remove two locknuts (5), washers (4), screws (1), and holddown striker (2) from bracket (3). Discard
locknuts (5).
2.
Remove two locknuts (7), washers (8), capscrews (9), washers (8), and bracket (3) from left hatch
panel (6). Discard locknuts (7).
NOTE
This task covers the left hatch panel holddown striker. The right
hatch panel holddown striker is mounted directly on the panel.
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2, M998, M998A1, M1035,
M1035A1, M1035A2, M1037, M1038, M1038A1,
M1042, M1097, M1097A1, M1097A2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two locknuts (Appendix G, Item 70)
Two locknuts (Appendix G, Item 107)
Manual References
TM 9-2320-280-24P
b. Installation
1.
Install striker (2) on bracket (3) with two screws (1), washers (4), and locknuts (5).
2.
Install bracket (3) on left hatch panel (6) with two washers (8), capscrews (9), washers (8),
and locknuts (7). Tighten locknuts (7) to 6 lb-ft (8 N
•
m).
TM 9-2320-280-20-3
Change 2
11-67