TM-9-2320-280-34
TRUCK, UTILITY: M998 SERIES
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
JANUARY 1996
TM-9-2320-280-34 - Page 1125 of 1258
2 2 - 9 . 5 .
RIGHT REAR FLOOR PANEL REPAIR (Co n
t ’ d)
TM 9-2320-280-34
2 2 -1 6 . 7 2
Change 1
This task covers:
a. Right Rear I n s e rt Panel Fabrication
g. Metal Strip C and Insert Panel Assembly
b. Reinforcement Strips Fabrication
h. Metal Strip E and Insert Panel Assembly
c. Metal Strips Fabrication
i. Metal Strip D and Insert Panel Assembly
d. Right Rear Floor Panel Removal
j. Right Rear Floor Panel and Insert Panel Drilling
e
. R e i n f o rcement Strip Aand Insert Panel A s s e m b l y
k
. I n s e rt Panel and Right Rear F l o o r Panel Installation
f. R e i n f o rcement Strip B and Insert Panel A s s e m b l y
INITIAL SETUP:
Tools
General mechanic’s tool set
automotive (Appendix G, Item 1)
Manual References
TM 9-2320-280-20
TM 9-2320-280-24P
TM 43-0139
Materials/Parts
Eighty-five rivets (Appendix E, Item 143)
Sixty rivets (Appendix E, Item 144)
Adhesive (Appendix B, Item 1.1)
Adhesive sealant (Appendix B, Item 4.1)
Sheet metal (Appendix E, Item 200.1)
Equipment Condition
• Right seat back removed
(TM 9-2320-280-20).
• Right rear seat bottom removed
(TM 9-2320-280-20).
• Right rear floor insulation removed
(TM 9-2320-280-20).
Maintenance Level
General Support
1.
Cut insert panel (1) from sheet metal, and mark four reference lines (3) and directional arrow (2) on
insert panel (1).
2.
Locate, mark, and drill six 0.312-in. diameter holes and one 1.00-in. diameter hole through
insert panel (1).
3.
Fabricate two drain holes (4) in insert panel (1).
4.
Bend insert panel (1) 1.50 in.
5.
Remove all burrs and round all sharp edges of insert panel (1).
a
. Right Rear I n s e rt Panel Fabrication
NOTE
All dimensions in this procedure are in inches.
Back to Top
