TM-9-2320-280-34

TRUCK, UTILITY: M998 SERIES

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

JANUARY 1996
TM-9-2320-280-34

  TM-9-2320-280-34 - Page 482 of 1258

TM 9-2320-280-34
7-9.
TRANSMISSION/TRANSFER CASE ASSEMBLY INSTALLATION (4L80-E)
This task covers:
Installation
INITIAL SETUP:
Applicable Models
Manual References
M997A2, M1025A2, M1035A2, M1043A2,
TM-9-2320-280-10
M1045A2, M1097A2
TM 9-2320-280-20
TM 9-2320-280-24P
Tools
General mechanic's tool kit:
Equipment Condition
automotive (Appendix G, Item 1)
Transmission/transfer case assembly prepared for
installation (para.
7-10).
Materials/Parts
Two lockwashers (Appendix E, Item 83)
General Safety Instructions
Two cotter pins (Appendix E, Item 8)
•
Torque converter must be installed with trans-
Four tiedown straps (Appendix E, Item 210)
mission as an assembly.
Transmission must be
Locknut (Appendix E, Item 60)
level.
•
Do not use hand to free transmission/transfer
case assembly of hang-ups or snags.
Personnel Required
One mechanic
One assistant
Maintenance Level
Direct support
NOTE
The following maintenance procedure applies to vehicles with 4L80-E
transmissions.
Refer to para.
7-7 for 3L80 transmission installation.
Installation
WARNING
Torque converter must be installed with transmission as an assembly.
Keep transmission level.
The torque converter may slide off front of
transmission and cause injury to personnel or damage to converter.
CAUTION
•
Torque converter must be properly installed in transmission or
transmission damage will result.
•
Safety chain must be routed under transmission oil cooler lines or
damage to cooler lines will result.
7-21


Back to Top