TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 1033 of 1320

TM 9-2320-304-14&P

5-269

Direct Support and General Support Maintenance (Cont)

(4)

Remove quick release pin (3) and pin (4) from short strut (5) and long strut (2).

(5)

Using handle of arm assembly (6), rotate arm assembly out to separate short strut (5) and long

strut (2).

(6)

Position flip lock (7) up to hold arm assembly (6) out. Release arm assembly.

NOTE

•

Rotating pin end of long strut counterclockwise 1/2 turn will decrease width

measurement by approximately 1/16 in. (1.59 mm).

•

Rotating pin end of long strut clockwise 1/2 turn will increase width measurement

by approximately 1/16 in. (1.59 mm).

•

Adjust both RH and LH long struts equally to obtain the correct width

measurement.

(7)

Remove screw (8) and cushion clip (9) from long strut (2).

CAUTION

Do not unscrew pin end too far. Gap between long strut tube and pin end flange should not

exceed 1.00 in. (2.54 cm). Failure to have sufficient engagement of pin end into long strut

could result in damage to equipment.

(8)

Rotate pin end (10) as required for correct width measurement.

Change 3