TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 1035 of 1320

TM 9-2320-304-14&P

5-271

Direct Support and General Support Maintenance (Cont)

NOTE

•

Make sure slider arm is deployed.

•

Both flip lock brackets are adjusted

the same way. Right side shown.

(16)

Remove quick release pin (3) and

pin (4) from short strut (5) and long

strut (2).

(17)

Using handle of arm assembly (6),

rotate arm assembly out and separate

short strut (5) from long strut (2).

(18)

Holding arm assembly (6) out, Soldier

A positions flip lock (7) up.

(19)

Soldier B measures gap between stop bolt (9) and right rear roller bracket (10).

NOTE

•

If gap is not 3/8

±

1/8 in. (9.5

±

3.2 mm), perform steps (20) and (21).

•

If gap is 3/8

±

1/8 in. (9.5

±

3.2 mm), go to step (22).

•

If dimension of gap is greater than 1.25 in. (3.18 cm) following adjustment, or proper

adjustment cannot be done, replace stop bolt with 2.50-in. (6.4 cm) long stop bolt.

(20)

Loosen jam nut (11) and adjust stop bolt (9) as required.

(21)

Tighten jam nut (11) on stop bolt (9).

(22)

If proper adjustment could not be made, repeat steps (18) through (21) using longer bolt.

Change 1