TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 552 of 1320

TM 9-2320-304-14&P

4-154

Organizational Maintenance Instructions (Cont)

4-30. GENERAL WIRE HARNESS REPAIR (CONT).

c. Type 3 Connector Repair.

(1) Disassembly.

(a)

Slide outer shell (1) back on

wire (2).

(b)

Remove C-washer (3) from wire (2).

(c)

Cut terminal (4) from wire (2).

(d)

Trim end of wire (2) as needed to

make an undamaged end.

NOTE

If trimming causes wire to become too

short, refer to TM 43-0158.

(e)

Remove 0.375 in. (1.0 cm) of

insulation (5) from end of wire (2).

(2) Assembly.

(a)

Install terminal (1) on wire (2).

(b)

Install C-washer (3) on wire (2) just

below terminal (1).

(c)

Slide outer shell (4) over

C-washer (3) and terminal (1).

(d)

Be sure no bare wire (2) is visible

outside of outer shell (4).

d. Type 4 Connector Repair.

(1) Disassembly.

(a)

Slide outer shell (1) and sleeve (2)

back on wire (3).

(b)

Remove contact (4) from wire (3).

(c)

Trim end of wire (3) as needed to

make an undamaged end.

NOTE

If trimming causes wire to become too

short, refer to TM 43-0158.

(d)

Remove 1/4 in. (.6 cm) of

insulation (5) from end of wire (3).