TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 555 of 1320

TM 9-2320-304-14&P

4-157

Organizational Maintenance Instructions (Cont)

NOTE

Wire and seal should be positioned so

larger wings of terminal will crimp around

seal and smaller wings will crimp around

exposed bare wire.

(e)

Position wire (1) on terminal (3).

(f)

Press handles of crimp tool

together until ratchet releases and

crimp is complete.

(g)

Push new terminal (3) and wire (1)

through connector (5) until seated.

(h)

Close two secondary locks (6) on

connector (5).

(i)

Connect connector (5).

f. Group II Terminal Repair.

(1) Disassembly.

NOTE

•

Connector is removed by gently

prying up on clip and pulling on

connector.

•

All Group II connectors are repaired

the same way. Number of wires in

connector may vary.

•

Both halves of connector are

repaired the same way.

(a)

Disconnect connector (1).

(b)

Unlatch and remove two secondary

locks (2) on connector (1).