TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

  TM-9-2320-328-13-P-1 - Page 426 of 1318

TM 9-2320-328-13&P-1
0058-6
DRAFT
0058
HWT0398
WARNING
ICON 72
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
Step 7.
Release bumper turret control agent discharge button (WP 0004).
Connect air line at
bumper turret foam metering valve.
Disconnect pump house wire harness bumper
turret foam metering control valve connector.
While an assistant pushes and holds
bumper turret discharge button (WP 0004), with a test lead set, check for 22 to 28 VDC
between pump house wire harness wire 2837 (gray) at bumper turret foam metering
control valve connector, terminal 1, and a known good ground.
If 22 to 28 VDC are not present, repair wire 2837 in pump house wire
harness if repairable (TM 9-2320-325-14&P), or replace
pump house wire
harness (WP 0302).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION


Back to Top