TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 825 of 1390

TM 9-2320-328-13&P-2

0237-5

DRAFT

0237

Change 1

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

-

14. Remove four nuts (30), lockwashers (31), eight washers (32), four screws (33), and bracket (17) from pump

house frame (34) and vehicle.

Discard lockwashers.

END OF TASK

INSTALLATION

NOTE

Perform Steps (1) through (9) if bracket was removed.

1.

Install bracket (17) on pump house frame (34) with four screws (33), eight washers (32), four

lockwashers (31), and four nuts (30).

2.

Install No. 2 passenger side discharge valve (29) on bracket (17) (WP 0162).

3.

Install passenger side auxiliary inlet valve (28) on bracket (17) (WP 0159).

4.

Install pump drain valve (27) on bracket (17) (WP 0321).

5.

Install water pump blow out air line and fitting (26) on bracket (17) (WP 0384).

6.

Install water pump blow out valve (25) on bracket (17) (WP 0384).

7.

Install decals and data plates (24) on bracket (17) (WP 0326).

8.

Install foam system drain valve (23) on bracket (17) (WP 0171).

9.

Install striplight and bracket (22) on bracket (17) (WP 0215).

HWT2369