TM-9-2320-361-10
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
OPERATOR'S MANUAL
DECEMBER 1988
TM-9-2320-361-10 - Page 273 of 392
TM9-2320-361-10
2-54. OPERATION OF SLAVE RECEPTACLE KIT
To operate slave receptacle kit, refer to para. 2-19.
2-55. OPERATION OF TROOP SEAT AND COVERING KIT
To operate, remove, and install troop seats, refer to para. 2-25. To remove and
install covering, refer to para. 2-49.
2-56. OPERATION OF TROOP SEAT – CENTER MOUNTED
a. General.
Troop seat — center mounted kit is installed to double troop
transport capacity on cargo trucks (M35A2, M35A2C).
b.
To operate troop seats (1), refer to para. 2-25. Troop seats (1) are installed
on opposite sides of pocket assemblies (2).
2-57. OPERATION OF VAN BODY HEATER (PRIMARY AND
SECONDARY) KITS
a. General.
Van body primary heater kit is installed on M109A3 shop van and
M185A3 instrument repair shop trucks to warm van body in temperatures down
to -25°F (-32°C). Colder temperatures require addition of van body secondary
heater kit. Both heaters have flexible ducts that may be rerouted for spot heating
of individual pieces of equipment.
b. Operation of Body Heater.
NOTE
Van body primary and
secondary heaters are
operated the same way. This
procedure covers operation of
van body primary heater.
(1)
Open fuel tank shutoff cock (3)
by turning counterclockwise.
(2)
Supply 115-volt AC power to van if available. Refer to para. 2-28b. If
115-volt AC power is available, place converter selector switch (7) down to 115V
position.
(3)
If 115-volt AC power is not available, place power switch (9) in down
position. Place converter selector switch (7) up to 24V position
2-212
Back to Top
