TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 1001 of 1207

TM 9-2320-361-20

13-21. POWER DIVIDER PROPELLER SHAFT REPLACEMENT (M764)

This task covers:

a. Removal

c. Installation

b. Inspection

INITIAL SETUP:

APPLICABLE MODELS

REFERENCES (TM)

M764

LO 9-2320-209-12-1

TM 9-2320-361-10

MATERIALS/PARTS

TM 9-2320-361-20P

Eight lockwashers

Seal

EQUIPMENT CONDITION

GAA grease (Appendix C, Item 13)

Parking brake set (TM 9-2320-361-10).

1. Remove four nuts (2), lockwashers (3), screws (4), and yoke shaft (5) from flange (1). Discard

lockwashers (3).

2. Remove four nuts (12), lockwashers (11), two U-bolts (9), and yoke shaft (5) from end yoke (13).

Discard lockwashers (11).

3. Unscrew cap (6) from end yoke sleeve (10).

4. Remove seal (8) and washer (7) from cap (6). Discard seal (8).

Inspect all parts for cracks, bends, or breaks. Replace defective parts. If universal joint requires

additional maintenance, refer to para. 7-4.

1. Apply light coat of GAA grease to splines on yoke shaft (5).

2. Install cap (6), washer (7), new seal (8), and end yoke sleeve (10) on yoke shaft (5).

3. Tighten cap (6) on end yoke sleeve (10).

4. Tighten end yoke sleeve (10) on end yoke (13) with two U-bolts (9), four new lockwashers (11), and

nuts (12). Tighten nuts (12) 25-29 lb-ft (34-39 N·m).

5. Connect yoke shaft (5) on flange (1) with four screws (4), new lockwashers (3), and nuts (2).

13-36