TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 1005 of 1207

TM 9-2320-361-20

13-23. POWER DIVIDER CONTROL LEVER AND LINKAGE REPLACEMENT (M764)

This task covers:

a. Removal

c. Adjustment

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

M764

MATERIALS/PARTS

Two cotter pins

Locknut

REFERENCES (TM)

TM 9-2320-361-10

TM 9-2320-361-20P

EQUIPMENT CONDITION

Parking brake set (TM 9-2320-361-10).

1. Remove cotter pin (3), clevis pin (1), and control rod (5) from power divider shaft (2). Discard cotter

pin (3).

2. Remove cotter pin (14), clevis pin (11), and control rod (5) from control lever (12). Discard cotter

pin (14).

3. Remove locknut (10), screw (7), washer (13), spacer (8), and control lever (12) from bracket (9).

Discard locknut (10).

Install control lever (12) to bracket (9) with spacer (8), washer (13), screw (7), and new locknut (10).

1. Adjust control rod (5) to 42.5 in. (108 cm) from center of both clevis holes (6) and (4).

2. Install control lever (5) to power divider shaft (2) with clevis pin (1) and new cotter pin (3).

3. Connect control rod (5) to control lever (12) with clevis pin (11) and new cotter pin (14).

13-40