TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 1014 of 1207

TM 9-2320-361-20

14-7. OIL PAN SHROUD AND EXHAUST TUBE REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

All

EQUIPMENT CONDITION

Parking brake set (TM 9-2320-361-10).

MATERIALS/PARTS

GENERAL SAFETY INSTRUCTIONS

Three cotter pins

Do not touch hot exhaust system components with

Four lockwashers

bare hands.

Locknut

REFERENCES (TM)

TM 9-2320-361-10

TM 9-2320-361-20P

a. Removal

WARNIN G

Do not touch hot exhaust system components with bare hands;

injury to personnel will result.

1. Remove cotter pin (9) and exhaust tube (10) from oil pan shroud (6). Discard cotter pin (9).

2. Remove two cotter pins (12), elbow (13), and exhaust tube (10) from heater (14). Discard cotter pins (12).

3. Remove locknut (1), screw (3), clamp (2), and exhaust tube (10) from splash shield (4). Discard locknut(1).

4. Remove exhaust tube (10) from vehicle.

5. Remove four screws (8), lockwashers (7), and oil pan shroud (6) from engine oil pan (5). Discard

lockwashers (7).

b. Installation

1.

2.

3.

4.

5.

Install oil pan shroud (6) on engine oil pan (5) with four new lockwashers (7) and screws (8).

Install exhaust tube (10) on oil pan shroud (6) with new cotter pin (9).

Insert exhaust tube (10) through hole (11) in toolbox.

Install elbow (13) and exhaust tube (10) on heater (14) with two new cotter pins (12).

Install exhaust tube (10) on splash shield (4) with clamp (2), screw (3), and new locknut (1).

14-9