TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 1019 of 1207

TM 9-2320-361-20

14-10. THERMAL BARRIER INSULATION REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

EQUIPMENT CONDITION

All

Parking brake set (TM 9-2320-361-10).

MATERIALS/PARTS

Driver’s seat removed (para. 11-28).

Companion seat removed (para. 11-26).

Adhesive sealant (Appendix C, Item 4)

Methylethylketone (Appendix C, Item 16)

REFERENCES (TM)

TM 9-2320-361-10

TM 9-2320-361-20P

NOTE

All thermal barrier insulation is removed the same way. This

procedure covers replacement of left rear insulation panel only.

1. Pull panel (2) away from cab interior (1). Discard panel (2) if irreparable damage occurs when

removing.

2. Clean all remaining insulating material and adhesive from contact surface areas.

b. Installation

1.

2.

3.

4.

5.

CAUTION

Once panel is coated with methylethylketone and put in place, it

cannot be moved. Be careful not to place panel in the wrong

position.

NOTE

Make all necessary cutouts and slits in panels before installation.

Shiny side of panel must face outward.

Place panel (2) on cab (1) to check for fit.

Remove panel (2) and coat contact areas with methylethylketone.

Install panel (2) on cab (1) and press firmly into place.

NOTE

If additional adhesive sealant is required, perform steps 4 and 5.

Remove panel (2) and coat contact areas with adhesive sealant.

Install panel (2) on cab (1) and press firmly into place.

14-14