TM 9-2320-361-20
14-5. PERSONNEL HEATER FUEL FILTER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Two lockwashers
EQUIPMENT CONDITION
Antiseize tape (Appendix C, Item 27)
Parking brake set (TM 9-2320-361-10).
Hood raised and secured (TM 9-2320-361-10).
1. Disconnect tube (11) from fuel pump elbow (1) and adapter (10).
2. Disconnect fuel line (3) from tube (4).
3. Disconnect tube (4) from elbow (5).
4. Remove elbow (5) from tee (6).
NOTE
Perform step 5 if vehicle is equipped with engine coolant heater.
5. Disconnect fuel line (12) from tee (6).
6. Remove tee (6) from fuel filter (7).
7. Remove two screws (8), lockwashers (9), and fuel filter (7) from plate (2). Discard lockwashers (9).
8. Remove adapter (10) from fuel filter (7).
NOTE
Wrap male pipe threads with antiseize tape prior to installation.
1. Install adapter (10) on fuel filter (7).
2. Install fuel filter (7) on plate (2) with two new lockwashers (9) and screws (8).
3. Install tee (6) on fuel filter (7).
4. Install elbow (5) on tee (6).
5. Connect fuel line (3) to tube (4).
NOTE
Perform step 6 if vehicle is equipped with engine coolant heater.
6. Connect two fuel lines (12) and (4) to tee (6).
7. Connect tube (11) to fuel pump elbow (1) and adapter (10).
14-6