TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 1013 of 1207

TM 9-2320-361-20

14-6. EXHAUST TUBE REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

EQUIPMENT CONDITION

All

Parking brake set (TM 9-2320-361-10).

MATERIALS/PARTS

GENERAL SAFETY INSTRUCTIONS

Cotter pin

Do not touch hot exhaust system components with

Locknut

bare hands.

REFERENCES (TM)

TM 9-2320-361-10

TM 9-2320-361-20P

WARNIN G

Do not touch hot exhaust system components with bare hands;

injury to personnel will result.

1. Remove cotter pin (2) and exhaust tube (7) from personnel heater elbow (1). Discard cotter pin (2).

2. Remove two nuts (5), screws (3), clamps (4), and exhaust tube (7) from left front fender (6).

3. Remove locknut (8), screw (10), clamp (9), and exhaust tube (7) from splash shield (11). Discard

locknut (8).

4. Remove exhaust tube (7) from vehicle.

b. Installation

1. Install exhaust tube (7) on personnel heater elbow (1) with new cotter pin (2) through elbow (1) and

tube (7).

2. Install exhaust tube (7) on left front fender (6) with two clamps (4), screws (3), and nuts (5).

3. Install exhaust tube (7) to splash shield (11) with clamp (9), screw (10), and new locknut (8).

14-8