TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 433 of 1207

TM 9-2320-361-20

4-12. OIL PRESSURE GAGE, BATTERY AND GENERATOR GAGE, FUEL GAGE, AND

ENGINE TEMPERATURE GAGE REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

All

REFERENCES (TM)

TM 9-2320-361-10

MATERIALS/PARTS

TM 9-2320-361-20P

Two lockwashers

EQUIPMENT CONDITION

●

Parking brake set (TM 9-2320-361-10).

●

Disconnect battery ground cable (para. 4-48).

CAUTION

The 60 psi and 120 psi gages and sending units are not inter-

changeable. Do not interchange the 60 psi gage or sending unit with

a 120 psi gage or sending unit.

NOTE

Engine temperature, oil pressure, battery and generator, and fuel

gages are removed and installed the same. This procedure covers

the engine temperature gage.

a. Removal

1. Turn four lockstuds (5) ¼ turn to left and pull instrument cluster (7) away from instrument

panel (8).

NOTE

Tag wires for installation.

2. Disconnect wires (1) and (9) from engine temperature gage (6).

3. Remove two nuts (2), lockwashers (3), and bracket (4) from temperature gage (6). Discard

lockwashers (3).

4. Remove engine temperature gage (6) from instrument cluster (7).

b. Installation

1. Position engine temperature gage (6) through front of instrument cluster (7).

2. Install bracket (4) on temperature gage (6) with two new lockwashers (3) and nuts (2).

3. Connect wires (1) and (9) to engine temperature gage (6).

4. Position instrument cluster (7) to instrument panel (8) and install by turning four lockstuds (5)

¼ turn to right.

4-22