TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 717 of 1207
TM 9-2320-361-20
11-13. HOOD FASTENERS REPLACEMENT
This task covers:
a. Hood Holddown Fastener and Bracket Removal
d. Hood Support Hook Installation
b. Safety Latch Removal
e. Safety Latch Installation
c. Hood Support Hook Removal
f. Hood Holddown Fastener and Bracket Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Eight locknuts
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
NOTE
Hood holddown, companion seat fastner, fastener and windshield
holddown fasteners are replaced basically the same. Some fasteners
have additional hardware and reinforcements. This procedure
covers the hood holddown fastener only.
a. Hood Holddown Fastener and Bracket Removal
1. Unlatch fastener (15) from bracket (13).
2. Raise and secure hood (10).
3. Remove two locknuts (11), screws (16), and fastener (15) from brush guard (17) Discard
locknuts (11).
4. Remove two locknuts (12), screws (14), and bracket (13) from hood (10). Discard locknuts (12).
b. Safety Latch Removal
Remove two locknuts (20), screws (18), and safety latch (19) from hood (10). Discard locknuts (20).
I
c. Hood Support Hook Removal
1. Lower hood (10).
2. Remove hook (7) from clip (9).
3. Remove screw (8) and clip (9) from cowling (1).
4. Remove locknut (3), washer (4), nut (6), and hook (7) from bolt (5). Discard locknut (3).
5. Remove locknut (2) and bolt (5) from cowling (1). Discard locknut (2).
d. Hood Support Hook Installation
1. Install nut (6), bolt (5), washer (4), and new locknut (3) on hook (7). Install assembled hook (7) on
cowling (1) with new locknut (2).
2. Install clip (9) on cowling (1) with screw (8).
3. Install hook (7) on clip (9).
11-20
Back to Top
