TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 767 of 1207
TM 9-2320-361-20
11-35. WINDSHIELD WASHER RESERVOIR, TUBING, JET, AND PUMP REPLACEMENT
This task covers:
a. Windshield Washer Reservoir Removal
e. Windshield Washer Pump Installation
b. Windshield Washer Tubing Removal
f. Windshield Washer Jet Installation
c. Windshield Washer Jet Removal
g. Windshield Washer Tubing Installation
d. Windshield Washer Pump Removal
h. Windshield Washer Reservoir Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-361-10
MATERIALS/PARTS
Four locknuts
TM 9-2320-361-20P
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
Hood raised and secured (TM 9-2320-361-10).
a. Windshield Washer Reservoir Removal
1. Remove cover (17) with grommet (16) from reservoir (19). Remove strainer (18) from hose (7) and
hose (7) from grommet (16) and cover (17).
2. Remove three locknuts (24), two clamps (23), plate (22), two screws (21), washers (20), and
reservoir (19) from steering column (25). Discard locknuts (24).
b. Windshield Washer Tubing Removal
1.
2.
3.
NOTE
Tag hose and tubes for installation.
Disconnect tubes (4), (6), and (28) from valve (29).
Disconnect hose (7) and tubes (6) and (9) from tee connector (8).
Remove grommet (27) and hose (7) from dash panel (26).
c. Windshield Washer Jet Removal
Remove nut (5), washer (2), and jet (3) from cowling (1).
d. Windshield Washer Pump Removal
Remove locknut (10), washer (11), windshield washer pump (13), washer (14), and screw (15) from
instrument panel (12). Discard locknut (10).
e. Windshield Washer Pump Installation
Install windshield washer pump (13) on instrument panel (12) with washer (14), screw (15), washer (11),
and new locknut (10).
I
f.
Windshield Washer Jet Installation
Install washer (2) and jet (3) on cowling (1) with nut (5).
11-70
Back to Top
