TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 897 of 1207
12-70.
TM 9-2320-361-20
This task covers:
a. Compressor Removal
f. Drill and Stand Installation
b. Vice and Machine Swivel Base Removal
g. Grinding Machine Installation
c. Fire Extinguisher Bracket Removal
h. Fire Extinguisher Bracket Installation
d. Grinding Machine Removal
i.
Vice and Machine Swivel Base Installation
e. Drill and Stand Removal
j.
Compressor Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M185A3, M109A3
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Twenty-four lockwashers
EQUIPMENT CONDITION
PERSONNEL REQUIRED
Parking brake set (TM 9-2320-361-10).
Two
1. Remove two wingnuts (14), washers (15), and lockwashers (16) from compressor mounting base (12),
Discard lockwashers (16).
2. Remove wingnut (2), lockwasher (1), screw (4), ground strap (3), and two lockwashers (1) from
compressor mounting base (12) and angle (5). Discard lockwashers (1).
3. Remove top cabinet drawer (38) and three screws (7) from cabinet (6).
4. Remove compressor (13), three nuts (11), washers (10), lockwashers (9), and block (8) from
cabinet (6). Discard lockwashers (9).
Remove four nuts (39), lockwashers (40), screws (35), washers (37), and vice and machine swivel case (34)
from table (20). Discard lockwashers (40).
1. Remove fire extinguisher (36) from fire extinguisher mounting bracket (31).
2. Remove four nuts (29), washers (30), screws (17), lockwashers (18), and fire extinguisher mounting
bracket (31) from van body wall (19). Discard lockwashers (18).
Remove four wingnuts (27), lockwashers (28), screws (33), washers (32), and grinding machine (26) from
table (20). Discard lockwashers (28).
Remove four nuts (25), washers (24), screws (22), lockwashers (23), and drill and stand (21) from
table (20). Discard lockwashers (23).
12-114
Back to Top
