TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 401 of 764
TM 9-2320-361-34
15-24. 115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd)
b. Installation
CAUTION
Use care when installing wiring harnesses. Excessive snagging or
pulling may damage wires.
NOT E
Safety wire must be secured to wiring harnesses with electrical tape.
1.
2.
3.
4.
5.
Position main wiring harness
(2)
in roof (3).
Secure main wiring harness (2) by closing tabs (1).
Install three grommets (9) and two grommets
(13)
in van wall
(4).
Attach safety wires (7) to five wire leads (5), (6), (8), (11), and (12).
NOT E
Do not remove safety wire from wire leads
Pull safety wires (7) so that wire leads (5), (6), (8), (11),
until wires are connected.
and (12) are pulled through van wall (4).
15-90
Back to Top
