TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 399 of 764

TM 9-2320-361-34

15-24. 115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd)

41.

42.

43.

44.

45.

46.

47.

48.

49.

15-88

NOTE

Perform steps 41 and 42 for M185A3 vbehicles

Remove bushing (5) from nipple (6) and safety switch box (2).

Remove start/stop switch (9), two screws (7), switch bracket (8), and spacer

(10)

from van wall (11).

Remove four nuts (4), lockwashers (3), and safety switch box (2) from two mounting brackets

(1).

Discard lockwashers (3).

NOTE

Tag

wires, cables, leads, and terminals for installation.

●

Safety

wire

will

be

used

to

install

new

wiring

harness.

Do not cut

safety wire from spool until harness has been pulled from van and

proper length has been obtained.

Attach safety wires (14) to wire leads (12),

(13), (16), (18),

and

(19).

Remove three grommets (17) from van wall (11) and wire leads

(12), (13),

and

(16).

Remove two grommets (20) from van wall (11) and wire leads (18) and (19).

Pull wire leads (12),

(13), (16), (18),

and

(19)

out of van wall (11).

Remove safety wires

(14)

from wire leads

(12), (13), (16), (18),

and (20).

Cut safety wires (14) from spools (15).