TM-9-2320-361-34
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
MAY 1992
TM-9-2320-361-34 - Page 393 of 764
TM 9-2320-361-34
15-24. 115- AND 24-VOLT
WIRING HARNESS REPLACEMENT (Contd)
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
NOTE
Perform steps 6 and 7 on each side of van.
Remove cap (1), clip (2), and cover (3) from receptacle strip (4).
Pull receptacle wires (6) forward,
remove electrical tape from connectors (7) and cut receptacle
wires (6) from main wiring harness (5).
NOTE
Safety wire will be used to install new wiring
harness. Do not cut
safety wire from spool
until
harness
has
been pulled from van and
proper length has been obtained.
Attach safety wire (15) to 115-volt domelight wires (13).
Pull 115-volt domelight wires (13) out of van body (8).
Remove safety wire (15) from 115-volt domelight wires (13).
Cut safety wire (15) from spool (14).
Attach safety wire (15) to 24-volt domelight wires (12).
Pull 24-volt domelight wires (12) out of van body (8).
Remove safety wire (15) from 24-volt domelight wires (12).
Cut safety wire (15) from spool (14).
Attach safety wire (15) to 115-volt domelight wires (11).
Pull 115-volt domelight wires (11) out of van body (8).
Remove safety wire (15) from 115-volt domelight wires (11).
Cut safety wire (15) from spool (14).
Attach safety wire (15) to 24-volt domelight wires (10).
NOTE
Both 115-volt receptacle connections are removed the same. This
procedure covers one connection.
Attach safety wire (15) to 115-volt receptacle connections (16).
Pull 24-volt domelight wires (10) and 115-volt receptacle connections (16) out of van body (8).
Remove safety wire (15) from wires (10) and 115-volt receptacle connections (16).
Cut safety wire (15) from spool (14).
Attach safety wire (15) to 115-volt domelight wires (9).
Pull 115-volt domelight wires (9) out of van body (8).
Remove safety wire (15) from wires (9).
Cut safety wire (15) from spool (14).
15-82
Back to Top
