TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 564 of 764

TM 9-2320-361-34

16-3.

REAR WINCH REPAIR (M756A2) (Contd)

f. Rear Winch Gearcase Assembly

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

11.

12.

Install bearing (37) in gearcase (29).

Install bearing (35) on worm gear (36).

Install worm gear (36) and bearing (35) in gearcase (29).

Install new seal (34) in brakecase (31).

Install new gasket (30) and brakecase

(31)

on gearcase (29) with four new lockwashers (32) and

screws (33).

Install new seal (39) in bearing cap (28).

Install new gasket (38) and bearing cap (28) on gercase (29) with four new lockwashers (27) and

screws (26).

Install dial indicator on gearcase (29) with plunger positioned on the end of worm

gear (36).

Measure end play of worm gear (36) by moving worm gear (36) back and forth. End play should not

be less than 0.005 in. (O.127 mm).

Remove dial indicator from gearcase (29).

NOTE

If end play is correct, go to step 13. If end play is incorrect, go to

step 11.

Remove four screws (26), lockwashers (27), and bearing cap (28) from gearcase (29). Discard

lockwashers (27).

Perform steps 7 through 10 to install additional new gasket (38).

16-21