VOLTAGE TEST
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
WARNING
(1) Remove wing screw from power distribution
shelf.
(2) Loosen wing screw on electrical distribution
block cover.
(3) Remove electrical distribution block cover from
power distribution shelf.
(4) Set multimeter to volts DC.
(5) Connect positive (+) probe of multimeter to
terminal lug TL1.
(6) Connect negative (-) probe of multimeter to
known good ground and note reading on
multimeter.
(7) If 24 VDC is not present, go to step 2 of this
fault.
(8) If 24 VDC is present, contact supervisor,
Mobile Tracking System (MTS)
troubleshooting needs to be performed.
Change 2
2-2011
TM 9-2320-365-20-2