TM-9-2320-365-34-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-2 - Page 498 of 1414

TM 9-2320-365-34-2

9-20.2

Change 2

9-5.

FRONT AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE

REPLACEMENT (CONT)

(8)

Position universal joint (9) on drive yoke (4) with

two bearing cups (10) and four screws (11).

(8.1)Tighten four screws (11) to 26-35 lb-ft (35-47 N•m).

WARNING

CAUTION

Do not use steel hammers to seat bearing

cups in drive yokes.

Failure to comply

may result in injury to personnel or

damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply may

result in damage to equipment.

NOTE

•

There are two types of bearing cups,

those with tabs and those without.

Perform the following step in bearing cups

not equipped with tabs.

•

Wipe end of yoke bearing bores prior to

installation

NOTE

Perform the following step on kits equipped

with screws P/N C5H5-24-39.