TM-9-2320-365-34-2

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-2 - Page 500 of 1414

TM 9-2320-365-34-2

9-6. STEERING KNUCKLE MECHANISM REPLACEMENT

This task covers:

a. Removal

b. Installation

c. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-365-10).

Front axle shaft removed (para 9-3).

Tools and Special Tools

Tool Kit, Genl Mech (Item 68, Appendix B)

Goggles, Industrial (Item 25, Appendix B)

Gloves, Rubber (Item 23, Appendix B)

Indicator, Dial (Item 30, Appendix B)

Multiplier, Torque Wrench (Item 35, Appendix B)

Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)

Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)

Sling, Cargo (Item 48, Appendix B)

Tools and Special Tools (Cont)

Jack, Dolly Type, Hydraulic (Item 31, Appendix B)

Tie Down, Cargo Aircraft (Item 64, Appendix B)

Materials/Parts

Pin, Cotter (Item 226, Appendix F) (left side)

Pin, Cotter (Item 227, Appendix F) (right side)

Nut, Self-Locking (Item 126, Appendix F)

Seal, Non-metallic (2) (Item 261, Appendix F)

Bearing, Washer, Thrust (Item 1, Appendix F)

Rag, Wiping (Item 59, Appendix C)

Dispenser, Pressure Sensitive Adhesive Tape (Item

31, Appendix C)

Personnel Required

(2)

WARNING

Wear appropriate eye protection when

working

under

vehicle

due

to

the

possibility of falling debris.

Failure to

comply may result in injury to personnel.

a. Removal.

(1) Remove cotter pin (1), nut (2), and tie rod (3) from

steering knuckle (4). Discard cotter pin.

9-22