TM-9-2320-365-34-2
M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2
AUGUST 2005
CHANGE 2
TM-9-2320-365-34-2 - Page 491 of 1414
TM 9-2320-365-34-2
Change 2
9-16.3/(9-16.4 Blank)
(7)
Position universal joint (9) on drive yoke (10) with
two bearing cups (11) and four screws (12).
(7.1)
Tighten four screws (12) to 26-35 lb-ft (35-47 N•m).
(8) Tighten four screws (12).
WARNING
CAUTION
Check bearing cups to ensure all needle
bearings are in place prior to installation.
Replace bearing cups if needle bearings are
missing or out of place.
Failure to comply
may result in damage to equipment.
NOTE
•
Wipe end of yoke bearing bores prior to
installation.
•
There are two types of bearing cups,
those with tabs, and those without.
Perform the following step on bearing
cups not equipped with tabs.
NOTE
Perform the following step on kits equipped
with screws P/N C5H5-24-39.
NOTE
•
Perform the following step on kits
equipped with shear head screws.
•
Alternately tighten screws.
•
When correct torque is reached, bearing
cap screw small hex head will break off.
Do not use steel hammers to seat bearing
cups in drive yokes.
Failure to comply
may result in injury to personnel or
damage to equipment.
Back to Top
