TM 9-2320-365-34-2
18-32
Change 2
18-4.
DIGITIZATION KIT INITIAL INSTALLATION (CONT)
(28) Enlarge five holes at location (18) to 17/32” (13
mm).
(29) Enlarge five holes in plastic cab liner (5) at
locations (18) to 1/2” (13 mm).
(30) Apply primer and paint to rear cab wall holes at
locations (18).
(31) Apply primer and paint to five rivnuts (6).
(32) Install five rivnuts (6) in rear cab wall (2) at
locations (18).
(33) Position LH roof template (19) on cab roof (8) with
two clamps.
(34) Drill three 3/16” (5 mm) pilot holes at locations (20).
(35) Remove two clamps and LH roof template (19) from
cab roof (8).
CAUTION
Enlarge holes only in plastic wall covering,
pull plastic away from rear cab wall if
necessary.
Failure to comply may result in
damage to equipment.
NOTE
Use primer and paint as indicated in TM
Paint TB43-0242.