TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1339 of 1824
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-775
2-775
2-775
2-775
2-775
CONTINUITY TEST
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
(4)
Apply brakes (TM 9-2320-366-10-1) and note
reading on multimeter.
(5)
If continuity is not present, go to step 5 of
this fault.
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
PDP, terminal 85, where relay K6 was removed.
(3)
Connect negative (-) probe of multimeter to
ground.
NOTE
Full system air pressure is required
to actuate stoplights.
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
PDP, terminal 30, where relay K6 was
removed.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If 12 vdc is not present, repair wire 1641
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Position master power switch to off
(TM 9-2320-366-10-1).
Back to Top
