TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 655 of 1632

CONTINUITY TEST

(1)

Remove kick panel (para 16-3).

(2)

Disconnect connector P108 from connector

J108.

(3)

Set multimeter to ohms.

(4)

Connect positive (+) probe of multimeter

to connector P910 socket 1.

(5)

Connect negative (-) probe of multimeter

to connector J108 pin 8 and note reading

on multimeter.

(6)

If continuity is not present, repair wire

2045 from connector P910 socket 1 to

connector J108 pin 8 (para 2-45) or

replace auxiliary panel cable assembly

(para 7-58).

(7)

Connect connector P108 to connector

J108.

(8)

Install kick panel (para 16-3).

(9)

Connect connector P910 to tailgate

release switch.

(10)

Position auxiliary panel on auxiliary

panel housing with six screws.

(11)

Tighten six screws to 24 lb-in. (3N.m).

TM 9-2320-366-20-2

Change 1

2-1477

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.