TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 663 of 1632

CAUTION

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to connector L8 socket 1.

(3)

Connect negative (-) probe of multimeter

to ground and note reading on

multimeter.

(4)

If continuity is not present, go to step 4

of this fault.

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to terminal 1 on up solenoid.

(3)

Connect negative (-) probe of multimeter to

terminal 2 on up solenoid and note

reading on multimeter.

(4)

If continuity is not present, replace

solenoid valve (para 7-142).

(5)

If continuity is present, notify DS

Maintenance to perform Dump Body

Hydraulic System troubleshooting task

k1. Dump Body Does Not Raise.

(6)

Connect connector L8 to solenoid

valve.

(7)

Tighten screw in connector L8.

CONTINUITY TEST

Change 2

2-1483

TM 9-2320-366-20-2