TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 659 of 1632

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to connector P172 socket D.

(3)

Connect negative (-) probe of multimeter

to ground and note reading on multimeter.

(4)

If continuity is not present, repair wire

3079 from connector P172 socket D to

terminal lug TL78 (para 2-45) or replace

dump power cable assembly (para 7-125).

(5)

If continuity is present, repair wire 3079

from connector J172 pin D to connector L7

socket 2 (para 2-45) or replace dump cable

assembly (para 7-124).

(6)

Connect connector P172 to connector J172.

(7)

Start engine (TM 9-2320-366-10-1).

(8)

Engage PTO (TM 9-2320-366-10-1).

(9)

Lower dump body (TM 9-2320-366-10-1).

(10)

Disengage PTO (TM 9-2320-366-10-1).

(11)

Shut down engine (TM 9-2320-366-10-1).

TM 9-2320-366-20-2

Change 1

2-1479

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION