TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 667 of 1632

TM 9-2320-366-20-2

Change 1

2-1487

VOLTAGE TEST

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.

WARNING

(1)

Connect connector L8 to solenoid valve.

(2)

Tighten screw in connector L8.

(3)

Remove six screws from auxiliary panel.

(4)

Lift auxiliary panel outward to gain access.

(5)

Remove PDP cover from PDP (para 16-2).

(6)

Remove circuit breaker CB50 from PDP.

(7)

Disconnect connector P911 from DUMP

BED UP/DOWN switch connector.

(8)

Set multimeter to volts DC.

(9)

Connect positive (+) probe of multimeter

to P911 socket 3.

(10)

Connect negative (-) probe of multimeter

to ground.

(11)

Install circuit breaker CB50 in PDP and

note reading on multimeter.

(12)

If 24 VDC is not present, go to step 9 of

this fault.

(13)

Remove circuit breaker CB50 from PDP.