TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 681 of 1632

CONTINUITY TEST

CONTINUITY TEST

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to terminal 1 on down solenoid.

(3)

Connect negative (-) probe of multimeter

to terminal 2 on down solenoid and note

reading on multimeter.

(4)

If continuity is not present, replace

solenoid valve (para 7-142).

(5)

If continuity is present, notify DS

Maintenance to perform Dump Body

Hydraulic

System troubleshooting task k2. Dump Body

Does Not Lower.

(6) Connect connector L9 to solenoid

valve.

(7) Tighten screw in connector L9.

Change 2

2-1495

TM 9-2320-366-20-2

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to connector L9 socket 2.

(3)

Connect negative (-) probe of multimeter

to ground and note reading on

multimeter.

(4)

If continuity is not present, go to step 4

of this fault.