TM-9-2320-366-20-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-3 - Page 469 of 1396

NOTE

WARNING

Wear protective goggles to protect against

possible injury from release of high pressure

air.

Failure to comply may result in injury to

personnel.

AIR PRESSURE TEST STE/ICE-R TEST #50

(1) Remove wrecker control panel top cover

(para 14-4).

(2) Disconnect air hose from input fitting of

30K winch manifold assembly.

(3) Connect air hose to M1089 30K winch

pneumatic test adapter.

(4) Install STE/ICE-R 0-1000 PSI transducer in

M1089 30K winch pneumatic test adapter.

(5) Start engine (TM9-2320-366-10-1) and

allow vehicle to build air pressure.

(6) Perform STE/ICE-R Test #50 and note

reading on STE/ICE-R.

(7) If 75-120 PSI (518-827 kPa) is not present,

replace air hose (para 23-5).

(8) Shut down engine (TM 902320-366-10-1).

(9) Drain air tanks (TM9-2320-366-10-1).

(10) Remove STE/ICE-R 0-1000 PSI transducer

from M1089 30K winch pneumatic test

adapter.

(11) Disconnect air hose from M1089 30K

winch pneumatic test adapter.

TM 9-2320-366-20-3

Change 1

2-2428.5

Tag air hose and connection point prior to

disconnecting