TM-9-2320-366-20-4

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-4 - Page 595 of 1558

TM 9-2320-366-20-4

Change 2

9-2.3

e. Installation.

(1)

Install two grease fittings (1) in universal joint (2).

(2)

Position universal joint (2) on drive shaft (3) with

two bearing cups (4) and four screws (5).

(2.1)Tighten four screws (5) to 26-35 lb-ft (35-47 N•m).

WARNING

CAUTION

Do not use steel hammers to seat

bearing cups in drive yokes.

Failure to

comply may result in injury to personnel

or damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment

NOTE

Wipe end of yoke bearing bores prior to

installation.

NOTE

There are two types of bearing cups, those

with tabs and those without. Perform the

following step on bearing cups not

equipped with tabs.

NOTE

Perform the following step on kits equipped

with screws P/N C5H5-24-39.