TM-9-2320-366-34-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-2 - Page 568 of 1434

TM 9-2320-366-34-2

10-20.2

Change 2

10-2.

INTERMEDIATE AXLE ASSEMBLY REPLACEMENT (CONT)

(71) Tighten four screws (69).

(71.1) Tighten four screws (69) to 26-35 lb-ft (35-47 N•m)

(71.2)Fold tabs on four screws (69).

(72) Apply lubrication to grease fittings on drive shaft (64).

(73) Remove drive shaft (70) from frame (65).

(74)

Position universal joint (71) on drive yoke (72) with

two bearing cups (73) and four screws (74).

CAUTION

WARNING

CAUTION

Grease must flow from all four seals.

Failure to comply may result in damage to

equipment.

NOTE

Step (73) requires the aid of an assistant.

Do not use steel hammers to seat

bearing cups in drive yokes.

Failure to

comply may result in injury to personnel

or damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment.

NOTE

Wipe end of yoke bearing bores prior to

installation.

NOTE

Perform steps (71.1) and (71.2) on bearing

cups equipped with tabs.

NOTE

•

Perform step (71) on kits equipped with

shearhead screws.

•

Alternately tighten screws.

•

When correct torque is reached, bearing

cup small screw hex head will break off.