TM 9-2320-366-34-2
10-24.2
Change 2
10-3.
REAR AXLE BOGIE REPAIR (CONT)
(12) Remove three screws (13) and mounting
plate (12) from shaft (2).
(13) Remove bearing cone (11) from shaft (2).
(14) Add or remove ring spacers (8) as required to
obtain bearing backlash measurement of 0.002-
0.012 in. (0.05-0.30 mm).
(15) Install bearing cone (11) on shaft (2).
NOTE
Perform steps (13) through (15) if bearing
backlash measurement was not 0.002-0.012
in. (0.05-0.30 mm).