TM-9-2320-366-34-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-2 - Page 567 of 1434

TM 9-2320-366-34-2

Change 2

10-20.1

(67) Install 45-degree fitting (62) in intermediate differential

carrier (5).

(68) Connect differential air shift hose (63) to 45-degree

fitting (62).

(69) Remove drive shaft (64) from frame (65).

(70) Position universal joint (66) on drive yoke (67) with

two bearing cups (68) and four screws (69).

(70.1)Tighten four screws (69) to 26-35 lb-ft (35-47

N•m).

WARNING

CAUTION

NOTE

Step (69) requires the aid of an assistant.

Do not use steel hammers to seat

bearing cups in drive yokes.

Failure to

comply may result in injury to personnel

or damage to equipment.

Check bearing cups to ensure all needle

bearings are in place prior to installation.

Replace bearing cups if needle bearings are

missing or out of place.

Failure to comply

may result in damage to equipment.

NOTE

•

Wipe end of yoke bearing bores prior to

installation.

•

There are two types of bearing cups, those

with tabs and those without.

Perform step

(70) on bearing cups not equipped with tabs.

NOTE

Perform step (70.1) on kits equipped with

screws P/S C5 H5-24-39.